Walrus Audio Melee: Wall of Noise Pedal
We give you the two most quintessential effects that yield unruly amounts of power and influence to an instrumentalist: reverb and distortion. They have been harnessed and woven together for an eternity of ethereal power with The Melee: Wall of Noise. The Melee unapologetically uses a joystick to meld reverb and distortion into one massive blaze of sound. With the flip of the order switch, run the distortion into the reverb or reverb into distortion; signal chain is your call now. For the explorer, the Melee can run one of three different reverb programs Ambient, Octave, and Reverse.
In a less is more approach, we’ve intentionally decided on controls that are fun to use and will inspire a wealth of creative output. Use the joystick to control the amount of distortion by moving it up and down. Moving the joystick left and right will adjust your reverb mix. The tone and decay toggles have low, medium, and high settings. Modulation can be added to the wet signal by holding down the bypass switch and moving the decay toggle. The left position is no modulation, the middle is a slight
modulation, and the right is a high modulation.
The Melee is equipped with three different reverb programs, which can be changed by simultaneously
pressing the bypass and sustain stomp switches. Experiment with the order toggle switch to hear how
differently these all react in front and after the distortion!
• Ambient Reverb (Pink LED) - Huge reverb capable of massive trails and engulfing your chords into an
angry wash of sound. Great for soaring melodic lines or shoegaze-driven chord progressions.
• Octave Down Reverb (Yellow LED) - Similar to the Dark mode in the Slö, you’ll find an eerie lower
octave hovering in the reverb trail for a nice and dark atmospheric touch.
• Reverse Reverb with Feedback (Blue LED) - Add reversed reverb trails back into your signal, create
gentle melodies or push into reverse feedback overload. Big, slow, and sad chords love to hang out here.
Press and hold the sustain switch to ramp up the reverb trails. Release and the trails will ramp back
down to where the decay switch is currently set. The sustain switch can also latch in all three programs.
Press and release the Sustain switch to capture and sustain the current reverb decay for long pad-like
sounds in your wet mix. Press again to release the latch, and the reverb trail will taper off based on the
position of the decay knob.
• The Melee comes coated in a glossy neon pink enclosure with white, yellow, and green inks with
art by David Hüttner.
• The die-cast enclosure’s exact size is 3.62” x 4.79” x 3.14” (including joystick height).
• Three bypass modes, DSP, DSP+True, True Bypass
• Power requirements are 9VDC, center negative (200mA minimum).
• The use of an isolated power supply is recommended for powering all Walrus Audio Pedals.
• Daisy chain power supplies are not recommended.
• Power supply not included.